|本期目录/Table of Contents|

[1]徐永明,刘飞. 一种转子外径迭代的感应电机设计方法[J].电机与控制学报,2015,19(12):18-23.[doi:10. 15938 /j. emc. 2015. 12. 003]
 XU Yong-ming,LIU Fei. Design methodology of induction motor based on rotor diameter iterating [J].,2015,19(12):18-23.[doi:10. 15938 /j. emc. 2015. 12. 003]
点击复制

 一种转子外径迭代的感应电机设计方法(PDF)
分享到:

《电机与控制学报》[ISSN:1007-449X/CN:23-1 408/TM]

卷:
19
期数:
2015年12
页码:
18-23
栏目:
出版日期:
2015-12-31

文章信息/Info

Title:
 Design methodology of induction motor based on rotor diameter iterating

作者:
 徐永明 刘飞
 ( 哈尔滨理工大学 电气与电子工程学院,黑龙江 哈尔滨 150080)
Author(s):
 XU Yong-ming LIU Fei
 ( College of Electrical and Electronic Engineering,Harbin University of Science and Technology,Harbin 150080,China)
关键词:
感应电机 设计方法 转矩迭代
Keywords:
 induction motor design method torque iteration
分类号:
TM 302
DOI:
10. 15938 /j. emc. 2015. 12. 003
文献标志码:
A
摘要:
 针对传统感应电机设计方法中,使用过多经验公式和经验系数,计算准确性不足的问题,提出基于电机输出转矩约束,循环迭代转子外径的感应电机设计方法。该方法减少了经验系数和经 验公式的使用,根据设计转矩要求迭代确定转子外径,设计电机主要尺寸,并可以以此进行其他参 数及性能计算。文中按设计步骤给出了详细的计算公式,并通过样机实验验证了设计的有效性。 试验数据及相关分析表明,设计样机的输出转矩与计算值接近,误差在 3% 左右,且性能满足设计 要求,电机效率达到 91% 以上,适于工程应用。本方法已经应用于普通感应电机和潜油电机设计 当中。

Abstract:
 Focused on using too much empirical formula and coefficient,but lack of calculation accuracy in the traditional induction motor design theory,a new induction motor design method was presented,on the basis of rotor outer diameter iterating and motor output torque constraint. The use of empirical coeffi-cient and formula was reduced. Based on the design torque requirements,the motor outer diameter was de-termined and other major parameters of the motor were designed. Finally,calculation of other parameters and performance can also be finished according to these dimension. Detailed calculation formula was given and the effectiveness of the proposed method was verified through the test of the prototype. The test data and the relevant analysis indicate the output torque of test prototype is close to the calculated value,with the error near 3% . Also the performance of the motor meets the design requirements,and the motor effi-ciency is above 91% ,showing satisfactory suitability in engineering application. As a result,the presen-ted method has been used in ordinary induction motor and submersible motor design.

参考文献/References:

-

相似文献/References:

[1]曹玲芝,李春文,牛超,等.基于相邻交叉耦合的多感应电机滑模同步控制[J].电机与控制学报,2008,(05):586.
 CAO Ling-zhi,LI Chun-wen,NIU Chao,et al.Synchronized sliding-mode control for multi-induction motors based on adjacent cross-coupling[J].,2008,(12):586.
[2]张爱玲,王震宇,杨文杰.直接转矩控制系统中减小转矩脉动方案的比较[J].电机与控制学报,2008,(05):566.
 ZHANG Ai-ling,WANG Zhen-yu,YANG Wen-jie.Comparison between two kinds of reducing torque ripple of based on direct torque control[J].,2008,(12):566.
[3]吕刚,孙守光,马云双,等.城轨交通中直线感应牵引电机的效率最优控制[J].电机与控制学报,2009,(04):490.
 LV Gang,SUN Shou-guang,MA Yun-shuang.Efficiency optimal control of linear induction motor for urban rail transit[J].,2009,(12):490.
[4]王高林,陈伟,杨荣峰,等.无速度传感器感应电机改进转子磁链观测器[J].电机与控制学报,2009,(05):638.
 WANG Gao-lin,CHEN Wei,YANG Rong-feng,et al.Improved rotor flux estimator for sensorless induction motor[J].,2009,(12):638.
[5]邵英.采用Park变换感应电机转子复合故障检测[J].电机与控制学报,2010,(03):57.
 SHAO Ying.Feature extracting method of stator and rotor faults of induction motor by park vector rotating filter[J].,2010,(12):57.
[6]王榕生,吴汉光,黄灿水,等.多断条笼型转子感应电动机导条电流分布[J].电机与控制学报,2010,(04):59.
 WANG Rong-sheng,WU Han-guang,HUANG Can-shui,et al.Distribution of bar current on squirrel cage induction motor with multi-broken rotor bars[J].,2010,(12):59.
[7]王明渝,陈杨裕,邓威,等.定转子电阻在线辨识的感应电机转速估计方法[J].电机与控制学报,2010,(04):66.
 WANG Ming-yu,CHEN Yang-yu,DENG Wei,et al.Rotor speed estimation for induction motor with stator and rotor resistances online identification[J].,2010,(12):66.
[8]赵海森,刘晓芳,罗应立,等.电压偏差条件下笼型感应电机的损耗特性[J].电机与控制学报,2010,(05):13.
 ZHAO Hai-sen,LIU Xiao-fang,LUO Ying-li,et al.Losses characteristics of cage induction motors under voltage deviation conditions[J].,2010,(12):13.
[9]朱鹏,张晓锋,乔鸣忠,等.三次谐波电压注入的五相感应电机SVM-DTC方法[J].电机与控制学报,2010,(09):13.
 ZHU Peng,ZHANG Xiao-feng,QIAO Ming-zhong,et al.Five-phase induction motor SVM-DTC strategies with third harmonic voltage injection[J].,2010,(12):13.
[10]王庆龙,张兴.感应电机双滑模面变结构MRAS转速辨识[J].电机与控制学报,2010,(10):32.
 WANG Qing-long,ZHANG Xing.Double-manifold variable-structure MRAS speed identification for induction motor[J].,2010,(12):32.

备注/Memo

备注/Memo:
 收稿日期: 2015 - 03 - 03
基金项目: 国家自然科学基金( 51207036)
作者简介: 徐永明( 1979—) 男,博士,教授,研究方向为特种电机设计及电力变压器热问题 ;
刘 飞( 1991—) 男,硕士,研究方向为电机内算法及电力变压器计算。
更新日期/Last Update: 2016-03-14