|本期目录/Table of Contents|

[1]温嘉斌,许明宇.防爆型水冷电机内换热与温度场计算[J].电机与控制学报,2009,(03):393-397.
 WEN Jia-bin,XU Ming-yu.Calculation on heat exchange and temperature field in water-cooled explosion-proof motor[J].,2009,(03):393-397.
点击复制

防爆型水冷电机内换热与温度场计算(PDF)
分享到:

《电机与控制学报》[ISSN:1007-449X/CN:23-1 408/TM]

卷:
期数:
2009年03
页码:
393-397
栏目:
出版日期:
2009-05-15

文章信息/Info

Title:
Calculation on heat exchange and temperature field in water-cooled explosion-proof motor
作者:
温嘉斌; 许明宇
哈尔滨理工大学电气与电子工程学院; 哈尔滨工业大学电气工程系
Author(s):
WEN Jia-bin; XU Ming-yu
关键词:
防爆型水冷电动机 有限元 换热 温度场
Keywords:
water-cooled explosion-proof motors finite element method heat exchange temperature field
分类号:
TM301.4
DOI:
-
文献标志码:
A
摘要:
采煤机电机安装空间严格受限,随着电机设计容量的提升,使单位体积损耗(发热率)增大。为了研究该类电机的发热与冷却问题,在对防爆型水冷电机的结构、材料以及换热机理进行分析的基础上,建立了防爆型水冷电机的传热数学物理模型。采用有限元法对电机定、转子及水套的温度场进行了计算与分析。通过计算结果与实测值对比,验证所建传热模型可以真实反映实际传热过程。分析计算结果表明电机定子最高温度点位于定子上层绕组近气隙侧;定子齿是热量传递的主要通道,热流密度最大;选用适当的冷却水流速,可以用最小的代价获取所需的冷却效果。研究结果可以为采煤机电机热控制和优化设计提供理论依据。
Abstract:
The motor used in the shearer is installed in a limited space,with the increase of the design capacity,unit volume loss(heating rate) increases in it.In order to study the heating and cooling problems of the motor,heat transfer simulation model for water-cooled explosion-proof motor was established on the basis of analyzing its structure,materials,and heat exchange mechanism.Upon that the temperature field was calculated and analyzed in the stator,rotor and water jacket of the motor with finite element method.By comparing the experimental data and the calculated results,the model was verified.Calculation results show that the highest temperature of stator is in the upper layer of the coil near the air gap,and the Stator teeth is the main channel of heat transfer,in which the heat flux density is maximum,and the appropriate flow velocity of the cooling water can obtain the required cooling effect with the minimum cost.The works provide a theoretical basis for the thermal control and optimal design of water-cooled motor used in the shearer.

参考文献/References:

-

相似文献/References:

[1]胡笳,罗应立,李志强,等.永磁电动机不同运行条件下的损耗研究 [J].电机与控制学报,2009,(01):11.
 HU Jia,LUO Ying-li,LI Zhi-qiang,et al.Investigation of losses in permanent magnet synchronous motor under different operation conditions[J].,2009,(03):11.
[2]孟大伟,刘瑜,徐永明.潜油电机转子三维温度场分析与计算[J].电机与控制学报,2009,(03):367.
[3]杨艳,邓智泉,曹鑫,等.无轴承开关磁阻电机径向电磁力模型[J].电机与控制学报,2009,(03):377.
 YANG Yan,LIU Zhi-quan,CAO Xin,et al.Magnetic radial force model of bearingless switched reluctance motors[J].,2009,(03):377.
[4]赵镜红,张晓锋,张俊洪,等.圆筒永磁直线同步电机磁场和推力分析[J].电机与控制学报,2010,(01):12.
 ZHAO Jing-hong,ZHANG Xiao-feng,ZHANG Jun-hong,et al.Field and thrust analysis of tubular permanent magnet linear synchronous motor[J].,2010,(03):12.
[5]梁艳萍,王鸿鹄,张建涛,等.空冷汽轮发电机端部电磁场与涡流损耗研究[J].电机与控制学报,2010,(01):29.
 LIANG Yan-ping,WANG Hong-hu,ZHANG Jian-tao,et al.Research of end fields and eddy current losses for air-cooling steam-turbo-generator[J].,2010,(03):29.
[6]韩力,高强,罗辞勇,等.不同转子结构无刷双馈电机的运行特性对比[J].电机与控制学报,2010,(03):6.
 HAN Li,GAO Qiang,LUO Ci-yong,et al.Comparasion on the performance of brushless doubly-fed machine with different rotor structures[J].,2010,(03):6.
[7]吝伶艳,王淑红,熊光煜,等.分段式永磁直线同步电动机有限元分析[J].电机与控制学报,2010,(07):18.
 LIN Ling-yan,WANG Shu-hong,XIONG Guang-yu.FEM analysis of segmental-primary permanent magnet linear synchronous motor[J].,2010,(03):18.
[8]王淑红,熊光煜.分段式永磁直线同步电动机的磁阻力[J].电机与控制学报,2010,(10):56.
 WANG Shu-hong,XIONG Guang-yu.Detent force of segmental-primary permanent magnet linear synchronous motor[J].,2010,(03):56.
[9]李伟力,程鹏,张美巍,等.1.5MW永磁风力发电机电磁场与温度场计算与分析[J].电机与控制学报,2010,(12):52.
 LI Wei-li,CHENG Peng,ZHANG Mei-wei,et al.Electro-thermal analysis and calculation of a 1.5MW permanent magnet wind generator[J].,2010,(03):52.
[10]于明湖,张玉秋,卢琴芬,等.动磁式横向磁通直线振荡电机建模分析[J].电机与控制学报,2011,(02):1.
 YU Ming-hu,ZHANG Yu-qiu,LU Qin-fen,et al.Modeling and analysis of moving-magnet transverse-flux linear oscillatory motor[J].,2011,(03):1.

备注/Memo

备注/Memo:
黑龙江省自然科学基金(E200626);; 国家科技支撑计划(2008BAF34B04)
更新日期/Last Update: 2009-07-09